Lee Precision Pacesetter 3-Die Set 26 NOSLER

Lee Precision Pacesetter.26 Nosler 3-Die Set includes the exclusive Lee Factory Crimp die. It crimps the bullet in place more firmly than any other tool which prevent buckling of the case and makes for more accurate shooting. The die set also includes a Bullet Seating Die that works with almost any point style bullet. A simple finger adjustment is all that is needed to adjust the seating depth.

If you are reloading for more than one firearm or reloading cases that were fired in other firearms the Full Length Sizer Die is a must. These dies are your best buy. They also include a shell holder, powder dipper, load data and are packed in a durable storage box.

INCLUDES:

• Full Length Sizing Die
• Bullet Seating Die
• Factory Crimp Die
• Universal Shell Holder
• Powder Dipper
• Instructions
• Load Data

NOTES:

• For further Load Data try HODGDON Powder Co.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures

WARNING:

Ammunition reloading can be dangerous if done improperly, and should not be attempted by persons not willing and able to read and follow the instructions included with each product exactly.

• Always wear safety glasses when reloading and shooting.
• Ammunition loaded with these tools should be used in modern guns, in good condition.
• Children should not be permitted to reload ammunition without strict parental supervision.
• Primers and gun powders, like gasoline and matches, can be dangerous if improperly handled or misused.
• We do not accept responsibility for ammunition loaded with these tools, as we have no control over the manufacture and storage of components or the loading procedure and techniques used.